Ok I know how to install these, you know put them all togeter. Just a few questions that I was hoping someone w/ prior experience or who owns these products could answer.

1. How much do you cut the bumpstops for the neuspeed sports?

2. How do you move the ring that sets the pirch height on the knois.

3. Any advice on a spring pirch location for an even drop front and back?

 

To move the snap-ring, just push the end of the ring out of thee groove w/ a screwdriver and move it.

My car sat higher in back w/ stock suspension, so I figured that it would still sit higher in back w/ H&R springs (1.8/1.5). I was right. After driving on it a week w/ the perches at stock height, I dropped the rear perches down for an extra 5/8" drop. My car sits nice and even now. :thumbup: