http://www.2amracing.com/Guage%20Pod.JPG
http://www.2amracing.com/INCARpod1.JPG
http://www.2amracing.com/interiorturbo.JPG
http://www.2amracing.com/Parts/gaugepb.jpg
http://www.2amracing.com/Parts/gaugepa.jpg
Cordless Drill
2.25 Bore Bit
Swiss army Tool(knife)
180 Pvc(blk)
90 Pvc(blk){homedepot}


Cut 2.25 hole in center of 180 piece and insert the 90 piece. fine tune the fit with a utility tool or knife. Drill two small holes directly behind the fittins for the guages(for mech gauges)..I opted for a mid sized drill bit for the holes. I cleaned up the back using vinyl electric tape and the cluster sits snug on the dash by way of velcro. The wires/tubes are run thru a hole drilled in the defrost vent on the dash.

Total cost if you own the tools...3.85

fyi...i dont think I spelled gauge correctly even once in the title or entire thread

 

damn thats ghetto

 

You did there.

 

ghetto..but also...its cheap and I didnt waste 35$ on pillar pods and my gauges are in plain sight and not off in the distance near my Stereo and ac controls...

 

Double post ...but...another sleeper(sorta GSR<accord Ex)but none the less...nice ride ...very cool

 

What is that supposed to mean?

 

i'd have to give you points in the creative department. cant say the same for aesthetics

 

I see a gsr and ussually figure that it has a few mods and is probably quick if not fast. I just consider my car a little grocery mom car. there was no insult in the statement. Very nice car...just attempting to compliment

 

its...creativity i guess...hahaha

 

Oh, ok. Thanks for the compliments. We need more close up pictures of your car and setup.