http://www.2amracing.com/Guage%20Pod.JPG
http://www.2amracing.com/INCARpod1.JPG
http://www.2amracing.com/interiorturbo.JPG
http://www.2amracing.com/Parts/gaugepb.jpg
http://www.2amracing.com/Parts/gaugepa.jpg
Cordless Drill
2.25 Bore Bit
Swiss army Tool(knife)
180 Pvc(blk)
90 Pvc(blk){homedepot}
Cut 2.25 hole in center of 180 piece and insert the 90 piece. fine tune the fit with a utility tool or knife. Drill two small holes directly behind the fittins for the guages(for mech gauges)..I opted for a mid sized drill bit for the holes. I cleaned up the back using vinyl electric tape and the cluster sits snug on the dash by way of velcro. The wires/tubes are run thru a hole drilled in the defrost vent on the dash.
Total cost if you own the tools...3.85
fyi...i dont think I spelled gauge correctly even once in the title or entire thread
