Does anyone know if it is possible to bolt in gsr/trpe-r oil sprayers into an LS block? If so is there a site that explains or demonstrates it? Any help will be appreciated.

 

not possible

 

Your rods don't need any additional lubing. They're allergic to oil.

 

Allergic to oil?? Everyone on here tells me that they dont get enough oil in that set up thats why they fail all the time.

 

the VTEC squirters spray the undersides of the pistons for cooling purposes.

besides, someone already said the correct answer... no.

 

I know what the sprayers do. I was just asking if they coud be put in. Does anyone know of anyone who put an LS rotating assembly into a grs block?

 

I thought i sent you email. And if you might as well stick with GSR internals on a GSR block if you have that block to begin with. Oh no! a thirty-something cc loss of displacement! Of course you lose a little torque because of that and the r/s ratio.

 

You could always fabricate a custom setup.... but the short answer: nah!

 

Like he said above, it would take a little fabrication. If you were serious you could just run a tap line into into an oil galley and run some -4 line in the block to some custom squirters mounted at the right angle.