ok I'm at the last step to getting the '92 H23a1 started in my '94 Accord Ex


It don't run, but it turns ......I swapped the pins a6 + a11...and still havent got a run.....the motor ran fine when it was in my lude.......Also the ECU fuse kept popping ....later finding that the NEG pins were going to the POS pins in the plugs in the engine bay coming from the ECU....


Any answers and point-outs would be great! Thanks

 

are you getting spark and fuel?

 

I'm getting spark, but not in a normal process.......It only sparks 1-2 times while turning the engine......and yes im getting fuel.



Any feedback on why my ECU fuse blew when I first pluged my harness to the engine????? the car is a '94 Accord Ex that came with a SOHC VTEC 5-speed....the motor is a '92 Prelude Si H23a1 with a 5-speed



I've never been so confused in my whole life

 

sounds like you got some shorts in your wiring harness. i would go over everything you cut and spliced etc to make the harness fit.

 

Yes there are some shorts in the harness........More like the two different harnesses from the Accord and Prelude have wires going in differnt places.....

Anyone have some kind of wiring diagram of which wires to switch, cut, splice? Any info and point - outs would be great.

 

pick up the chiltons manual it has the wiring for the obd1 preludes and accords
all teh sensors are more or less in teh same area. its jsut a metter of exteding some wires, just make sure to use solder and heat shrink tubing...