Engine Swaps, Tech & Tuning Swaps, N/A Performance, Forced Induction, Engine Management, & Troubleshooting

Stupid Rotor!!

Reply Subscribe

Old

Apr 9, 2003 | 01:05 PM

#1

Baget

Thread Starter

All Show and No Go!

Joined: Aug 2002

Posts: 1,078

Likes: 0

From: MN

Default

Stupid Rotor!!

ok so i'm replacing all my stuff today. however the screw that is on the rotor is in the worst possible spot directly where i can't get at it.. is there a way to make the distrubtor move a bit so i can get at it?

thanks!

Reply

Old

Apr 9, 2003 | 01:18 PM

#2

Baget

Thread Starter

All Show and No Go!

Joined: Aug 2002

Posts: 1,078

Likes: 0

From: MN

Default

ugh anyone? i really dont' wanna have to start and stop my engine until it falls ina place where i can get at it...

Reply

Old

Apr 9, 2003 | 01:38 PM

#3

drift

Flaccid Member

Joined: Jul 2002

Posts: 571

Likes: 0

From: Seattle

Default

use a wrench to rotate the crank at the pulley. this will cause the dizzy rotor to rotate. line it up with the U shaped cutouts on the side of the dizzy to access the rotor set screw easily.

Reply

Old

Apr 9, 2003 | 01:41 PM

#4

Baget

Thread Starter

All Show and No Go!

Joined: Aug 2002

Posts: 1,078

Likes: 0

From: MN

Default

hmm ok i think that makes sense thank you

Reply

Old

Apr 9, 2003 | 02:38 PM

#5

Baget

Thread Starter

All Show and No Go!

Joined: Aug 2002

Posts: 1,078

Likes: 0

From: MN

Default

i just turned it over and that rotated it for me.. much easier

Reply

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last

All times are GMT -8. The time now is 01:55 PM.