I just intalled a Cold Air Intake on my 1990 Accord 2 dr EX. After I was done, there were two sensor (i think) hoses left that were no longer hooked up to anything. I believe one is from the Intake Air Temperature Sensor. And the other is from the starter sensor, where the engine gets air from the intake. There is no place to attach these hoses to the CAI. Any help would be appreciated! THANKS!!!!

 

Are you sure you got the right intake? Is it an AEM? The AEMs should all have provisions for factory sensors(especially considering the price). If it's not an AEM, then you can drill and tap holes for a hose barb to connect to the valve cover and a grommet for the AIT.