Will the existing wire from the ecu to the engine compartment fit the wires from the motor of a b16 out of an Si? Also would the axles and linkages line up correctly too? thanks

 

the wiring will work, i think the only thing you might have to do as ad one wire for the knock sensor.

im not too sure about the axles and linkage, when i did my swap it already came with the linkage and axles from the b16 so i just used them.

 

The '94 Si axles will not work on your b-series motor. The spline is different.

 

you need this: ECU, axles, shift linkage from a Del Sol or the SI these should come with the engine swap , and engine mounts from either a Del sol, SI, or an integra ...the wires should match up..but you may need to swap the harness that is in the engine compartment seeing how your going from SOHC to DOHC and there are some extra sensors that are not on your stock SOHC harness..my best friend just sawpped a B16A3 in his civic and thats what he had to add and sawp on his engine

 

we are swaping a harness from a gsr to the motor, therefore we are able to use the stock chasis harness, i would be interested in knowing what sensors i am going to have to wire in.