Will mitsubishi injectors work with my b16? More specific, http://cgi.ebay.com/ebaymotors/ws/eB...category=33554

will these injectors be better than my stock ones?

 

Your stock injectors are already 240cc.

 

I do believe those are peak and hold, so unless you have a resistor box and OBD-I style injectors clips, they won't work, and your stock injectors are 240cc, as was pointed out.

 

For some reason I thought they were lower cc's. What injectors would you recomend with all motor setups? I was going to go with a ls/vtec type motor but $ became short so I finished my b16a. (modded of course)

 

You can look for some 280cc Prelude injectors. The largest you can go on a stock ECM is about 310cc. I would run the stocks until you're sure you need more fuel and have a way to tune your fuel map.

 

On this note, Im building the piss out of a DOHC ZC... Its got an 11.16:1 CR and a 62mm TB with a modified Intake Manifold (Moded by Endyn for better airflow) I will be adding a 55-75 ZEX nitrous kit... What do you guys think I should be using? Also I will have a ZDyne Gold PM7.