Ok here is the deal, I am TRYING my damnest to build a JDM DOHC ZC engine... I see these WAY OVERPRICED HKS camshafts and Im thinkin about buying them $900 So here is the deal everywere I look I see them advertised as 86-89 integra-ZC camshafts... As we all know the ZC and D16A1 camshafts are NOT the same. Has anyone used these cams in a JDM ZC?
Also here are the specs... Intake: Duration - 256 Lift - 10.45mm
Exaust: Duration - 256 Lift - 9.17
Do these look like they would be good in a All Motor/Nitrous Oxide engine?

 

Why don't you just swap in a 1st gen B16A for $900. I would rather do that, than build a ZC with $900 cams.

 

Because I dont want Vtec, I aready bought the ZC and have it in my posesion. All I want to know is has anyone used these camshafts?
I have a point to prove with the ZC, because it is a D series motor... Well basicaly, I want to make one bad underdog! I will let you know how it turns out. I just opend my package from endyn which contained 11.16:1 CR pistons for the ZC...
But back to the point, anyone used these camshafts?

 

Crower sells some regrinds for the ZC for I believe $150 a piece, you have to call them and ask about it though as the info isn't on their website.

 

Yea... I think Im goin WEB. Same price, better grinds.