do they make high compression gaskets for non vtec motors??
Thread Starter
Junior Member
Joined: Aug 2002
Posts: 5
Likes: 0
do they make high compression gaskets for non vtec motors??
i was wondering if they make high comression gaskets for non-vtec motors
if they do can you give me a link or somthing cuz i need a nue head gasket badly , thanx :thumbup:
if they do can you give me a link or somthing cuz i need a nue head gasket badly , thanx :thumbup:
のんびり～(´ε｀)
Joined: Sep 2000
Posts: 2,314
Likes: 1
From: San Jo, Cali
Yes - Cometic
http://www.nipponpower.com/engine/index_gasket.html
The thinnest one is only 3 thousanths thinner than stock, though. You could do what other people do - take the middle layer out of the stock 3 layer gasket.
http://www.nipponpower.com/engine/index_gasket.html
The thinnest one is only 3 thousanths thinner than stock, though. You could do what other people do - take the middle layer out of the stock 3 layer gasket.
Senior Member
Joined: Aug 2002
Posts: 259
Likes: 0
From: USAF
YES YES and YES. Cometic is THE headgasket. I'm not buying another stock one. ever lol.
I had some scratches/dings on th deck of my block and it sealed without anything special... compression numbers are good... so YEA... GET ONE ;-)
They also made me one that was .067" thick to lower my comp but u need the opposite. Just watch your valve clearances. Not fun stuff.
Harry
I had some scratches/dings on th deck of my block and it sealed without anything special... compression numbers are good... so YEA... GET ONE ;-)
They also made me one that was .067" thick to lower my comp but u need the opposite. Just watch your valve clearances. Not fun stuff.
Harry