a 1994 B16A you mean, they only made the b16a2 in 99-00 Civic Si

That motor is OBD1 if its from 1994, but I got confused cuz you said B16A2.

Sorry, not trying to cuz problems, just make sure the engine is OBD1.

 

I'm the newbie....I thought the 2 referred to the 2nd generation of B16A.

 

how much did shippin cost ya. i went through their site, prices are good, but they are in canada, customs and international shippin n stuff, how much it cost u total??

 

Don't know yet. supposed to be $200.00 or so.

 

He is getting a JDM B16A2. Those came from the 92-95 civics over in Japan.

He is on the right path..your swap will go fine.

 

sorry didnt know that. I knew that it came in USDM 99-00 Si. Yea, you will be fine. No worries!

 

waiting for it to be done is the worst part...can't wait to see how it looks and performs

 

the B16A3 is what was in the Del Sol SI, my best friend had one in his 2k civic Ex. The engine was out of a 95 Del Sol, and was A PAIN IN THE ASS from the day he got it. Thank god that the car is now totalled and the nightmare is over.

 

My B16A just came in from Osaka JDM Motors!

Mechanic checked it out and all looks good so far. Install should start on Wednesday. Here are a couple of pictures:
http://www.geocities.com/therealmorr...ngineSwap.html

 

the b16a2 were used in euro market from 92-95 in vti and were obd1.also used in the 99-00 si usdm but I think it was a3 cuz when i order parts from honda the book they use list it as b16a3 just like the usdm delsol.so on that note if you need a harness you can look to the edm cuz those are left hand drive obd1 that will work but when I swapped my motor I used the vx harness ang only had the o2 and egr clips to deal witheverything else matchedand plugged right in rewire the o2 and run you wire for the vtec,knock sensor and you should be golden but check out hybrid-honda to make sure that is all.