Just a quick question about my DA...[B18B1 swap]
Thread Starter
Junior Member
Joined: Mar 2006
Posts: 51
Likes: 0
From: Allentown, PA
Just a quick question about my DA...[B18B1 swap]
I have a B18b1 going into a 90 teg. Do I have any modifications or problems to worry about (considering it originally came witha b18A)? Thx.
Apathy Kills
Joined: Nov 2002
Posts: 60,714
Likes: 0
From: The Left Lane
I'd bank on that, Snoops.
Moved to Engine Swaps.
Moved to Engine Swaps.
__________________
:: :ToDspin: - supermod - but who gives a shit?
:: HAN Integra FAQ: If, by some miracle, yours hasn't been stolen... check it out!
:: HAN Integra FAQ: If, by some miracle, yours hasn't been stolen... check it out!
Thread Starter
Junior Member
Joined: Mar 2006
Posts: 51
Likes: 0
From: Allentown, PA
Thx for moving. I have the cable tranny and motor in the car. Just need the harness now. I have the pr4 (obd0) ecu also. One guy on theintegraforums.com said this:
"uhhh....no, well you will have problems with the wiring of the distributor. Also, the ecu will be different. If you use the obd0 non vtec b series distributor you shouldn't have a problem, same with the ecu."
Sounds probable or DEF obd conversion? Thx ALOT for the help thus far fellas.
"uhhh....no, well you will have problems with the wiring of the distributor. Also, the ecu will be different. If you use the obd0 non vtec b series distributor you shouldn't have a problem, same with the ecu."
Sounds probable or DEF obd conversion? Thx ALOT for the help thus far fellas.
Last edited by kimsuprapa; Feb 11, 2007 at 10:42 AM.
