B16a swap Q
Thread Starter
Built B16a
Joined: Feb 2005
Posts: 556
Likes: 0
From: liverpool, UK
B16a swap Q
I have a 94 EG hatch with a B16a2 in it currently, ive just purchased a B16a1 out of a 91 crx, the intake manifolds look differant will the intake manifold off my civics b16a2 fit the b16a1 ok? i know it will bolt on, just wanna make sure it will run ok with it?
Senior Member
Joined: Jun 2005
Posts: 672
Likes: 0
From: Allentown PA, - Phila, PA
It should run fine, the bolt pattern is the same, so it will def bolt up...
Actually I have a B16A1 in my EG with a GSR head, with GSR IM (had to use GSR IM cause of unique bolt pattern on GSR head) and it runs great, no probs whatsoever...
Good luck!
Actually I have a B16A1 in my EG with a GSR head, with GSR IM (had to use GSR IM cause of unique bolt pattern on GSR head) and it runs great, no probs whatsoever...
Good luck!
Thread Starter
Built B16a
Joined: Feb 2005
Posts: 556
Likes: 0
From: liverpool, UK
Great, thanks for the help.
Im putting the B16a1 in because ive found a low mileage 60k motor......and id rather that 60k motor than my current 148k b16a2 motor because im boosting it this week.
Im putting the B16a1 in because ive found a low mileage 60k motor......and id rather that 60k motor than my current 148k b16a2 motor because im boosting it this week.