psx_pat

Ok,I have PR-3 ECU OBD-0 with B16A head and B20B block. I want to change my header with Integra type-R (4-1). The problem is PR-3 ECU using 2 O2 sensors on cylinder 1-4 and 2-3. So, where I should install the O2 sensors on 4-1 header and still using my PR-3 ECU? Also what you guys think type-R header for my engine set up (the engine is pretty much stock)? Thanks.

Illegal B16

put it at the top. i would get the lighter magan racing type-r header in stainless. Much cheaper as well. Comes with a bolt to block off the lower hole.

psx_pat

I'm not not sure about what you mean put it at the top? In what cylinders? 1 O2 sensor on cylinder 1 and the other o2 sensor on cylinder 2?

Illegal B16

nevermind.