Block Gaurds "Do or Dont"
#1
Registered User
Thread Starter
Join Date: May 2005
Location: Lumberton, NC
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
Block Gaurds "Do or Dont"
Just wanted to know if anyone has any problems with block gaurds distorting cyclinders. I read somewhere that someone installed a block gaurd and it caused one of his pistons to siezed up at the top of the cyclinderd. Due to the distortion created by the gaurd.
#2
gsr-t hatch in progress!
Join Date: Jun 2004
Location: Elyria, OH/St. Charles, IL
Posts: 397
Likes: 0
Received 0 Likes
on
0 Posts
if u ever put in a block guard it should be before you hone out the cylinders for new pistons, so the distortion will be corrected. there is no reason to just put in a block guard and not put in new pistons and rods.
#4
Still here... sorta...
Originally Posted by PacificDude
If anyone is going to go through that much work, might as well just get some good closed-deck sleeves.
I couldn't agree more.
#5
On permanent hiatus
Join Date: Jul 2004
Location: A forum with actual tech
Posts: 9,716
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by steven_SA
Just wanted to know if anyone has any problems with block gaurds distorting cyclinders. I read somewhere that someone installed a block gaurd and it caused one of his pistons to siezed up at the top of the cyclinderd. Due to the distortion created by the gaurd.
I agree with Westcoaststyle. Screw the work of a block guard and just get it sleeved.
#6
Originally Posted by Shmoo
The distortion isn't created by the guard, but rather the retards that decide to install it by smaking it in with a hammer. It needs to be machined to fit, welded in, the block needs to be redecked, and then the cylinders need to be rebored to correct any out-of-round.
I agree with Westcoaststyle. Screw the work of a block guard and just get it sleeved.
I agree with Westcoaststyle. Screw the work of a block guard and just get it sleeved.
I second (or third) that.