im having a problem with the wiring. i didnt want to buy a new wiring harness after the one on my new b16a first gen was cut i got the ecu without the clips that go into it.But i later bought the clip parts that fit into the ecu, but they only have a little bit of wire length. I was planing on just matching and extending the wires because i do have another b16a engine harness but its cut aswell and its a automatic. So what i have, is the harness that comes from the engine, the middle parts where the harness clicks into the harness from the fire wall, then the clip parts that are in the actual ecu. however some of the wires are a little different. i need a nice pinout of the harness from the engine to the ecu and what colors do what can any one help.

 

We have no idea what generation any of this stuff is. Need more info.
-PHiZ

 

Try go to this site, it might help
http://www.hondata.com/techwiringpw0.html

 

thanks. sorry it was a first gen b16 88-91 obd 0 but i found out already thanks again.

 

No,problem. Also could you find out, OBD-0 have 2 O2 sensors. one on exhaust #1&#4 and the other one is exhaust #3&#4. Which one is going to ECU pin number C16 (white cable). Thanks.