after receiving my engine swap the shop calls me to tell me that they forgot to put in 2 washers and some plastic round piece that looks like one of those top spinners in my rebuilt tranny. I've searched around but i couldn't find where these go... can anyone pint point where these go or do they have a picture of a tranny all fits in? btw its a b16a2 motor with the regular tranny that comes with it... i can't remember the model #

 

There are three places on the outside that need washers. The drain bolt, fill hole bolt and the back-up switch. Check those places if they have washers. If they are not those then you have some big problems if those washers are supposed to be in the tranny. I'd take it back to the shop that did the rebuilt and have them figure it out where they go. Perhaps some pics may help more.