y8 IM on a z6
Oct 30, 2003 | 04:14 PM
Thread Starter
Joined: Dec 2002
Posts: 3,196
Likes: 0
From: Newnan, Ga
y8 IM on a z6
Will the y8 intake manifold fit right in place of my z6 or will I have to do some adjusting?
Oct 31, 2003 | 09:27 AM
Thread Starter
Joined: Dec 2002
Posts: 3,196
Likes: 0
From: Newnan, Ga
Oct 31, 2003 | 09:16 PM
Joined: Dec 2002
Posts: 2,013
Likes: 0
From: Hawaii
it bolts right on. just get a new IM gasket.
Nov 1, 2003 | 09:27 AM
Thread Starter
Joined: Dec 2002
Posts: 3,196
Likes: 0
From: Newnan, Ga
Quote:
Originally posted by NeverBX it bolts right on. just get a new IM gasket.
Thanks....but was told it would only give me like 1-2hp so don't think it is worth the $60.
Nov 2, 2003 | 12:12 PM
Joined: May 2002
Posts: 4,019
Likes: 0
From: Bay Area, CA
I think the z6 intake ports are too small for the y8 intake manifold. If you're going to do that you might want to make the ports bigger.
Nov 2, 2003 | 12:54 PM
Joined: Dec 2002
Posts: 2,013
Likes: 0
From: Hawaii
Quote:
Originally posted by 93DituneEX Thanks....but was told it would only give me like 1-2hp so don't think it is worth the $60.
if i were you i'd buy it then sell it on ebay if you're not going to use it.
