ur local fabric store should have em.

 

how would black vinyl look look on the gray interior doors?? :rick:

 

nice job... could've done a better job on the vinyl on the corner of the armrest.. I'll give u 2 thumbs up for the attempt.

 

most likely it will start to bubble in a month cause of the heat. if it doesnt post some new pics after a months cause i know it will, believe me.

good DIY directions though. :thumbup:

 

a dremal with the small brown disks is the way to go when sutting the rivets off i just finished one door panel and im starting on the other dremalls are tha shit lol.
use the dremall to cut the top of the plastic rivet off (take care when cutting the rivets) as not to brake the disks and note witch way the disk spins.
then use a utility knife to cut around the hole in the middle of the rivets
and then just pull the panel.
if u want when the panel is off is to custom fiberglass a mold of the inner panel if you want to have a custom speaker panel/anything you want in there
if you havent done FIBERGLASS before its honestly a friggin JOKE the shit is so easy to use.

 

Man this has been revived so many damn times, anyway, does anyone have any pics of this done by themself? I'd like to see it finished, and NeverBX is right, glue and heat don't do well when you want to adhere something.

 

Back from the dead.

 

I should do something like this. I burned the door fabric with a cigarette one night :doh:

 

sure it was a cigarette???

 

basd on the avatar and name i'd say it was a very special cigarettee :bandito: