Tools: Sockets, wrenches, philips screw driver, dremel with cutting bit, Haynes Manual, other things that i cant think of.

Step 1: Take bumper off



Step 2: Take bumper and lip to a nice place to work on with lighting and power outlets. I took mine into the basement.

Step 3: Cut off ALL tabs off the lip.



Step 4: Mount Lip on bumper by holding lip in place and using something to mark where to drill holes. While doing this, mark the edges so u can cut the excess length. Use a dremel or hax saw to cut it or anything else.



Here's a pic of the bending:


Step 5: After marking holes, take a drill with the proper size drill bit and drill the holes.



Step 6: Put lip back on the bumper and put the bolts, washers and nuts in place.




Step 7: Tighten all the bolts and make sure they're all in place.




Step 8: Put bumper back on. Be carefull not to drop the bumper. Finish product should look like this:



GOODLUCK!!!

 

sweeeet. imma make a copy for the DIY forum. thanks a lot! great post. :thumbup: