i was going to gunk my engine bay but then i noticed this...

this is the wire that runs into my gauge (air fuel) and is connect(tapped) into the 02 sensor...

 

its almost broke...could this be a problem?

 

youre stupid.

 

^----- uncalled for. but bdi, this isnt a big of a problem. go to auto zone and buy you some heat shrink wire wrap or some crimping wire connectors. strip both ends of the wire and connect with either solder and a shrink wrap or a crimping wire tie. the crimping is a quick fix but looks ugly and is known to come undone....the heat shrink wrap is a better b/c of solder and a cleaner way to go. if you go shrink wrap be sure to slide it over the wires and out of the way before soldering cause you cant put it on once its connected together.

 

:rofl:

It's just a wire. Fix it, it's not going to kill you.

 

I have a free sample of Gunk Engine Cleaner (they have a degreaser too, this confuses me)...Hmm, my engine isn't that dirty. Oh well.

 

i got 3 warning points for that :rofl:

 

warning points???? and how do you get them??