intermediary (jack) shaft
07-18-2003, 06:32 PM
#1
Registered User
Thread Starter
Join Date: Mar 2003
Location: Tucson AZ
Posts: 1,412
Likes: 0
Received 0 Likes
on
0 Posts
intermediary (jack) shaft
ok i now know the 87 integra intermediary shaft will not work on my zc, what intermediary shaft should i have, how would i find the correct shaft???? please help asap TIA i was reading that the 88-89 integra wont work?...???
07-21-2003, 04:19 PM
#5
Registered User
Thread Starter
Join Date: Mar 2003
Location: Tucson AZ
Posts: 1,412
Likes: 0
Received 0 Likes
on
0 Posts
ahhh im getting such conflicting information, i now have some ppl telling me that u can use the 88-89 anyone know for sure if it is compatable? the 87 definitely wont work anyone know? please help asap
07-21-2003, 07:36 PM
#7
Registered User
Thread Starter
Join Date: Mar 2003
Location: Tucson AZ
Posts: 1,412
Likes: 0
Received 0 Likes
on
0 Posts
yah on the zcr.com it says the 88 and 89 wont work and that those jackshafts will only work on the same d series engines but arent the zc a type of d series engine? and this shop keeps insisting that those are the right jackshafts
07-22-2003, 07:41 AM
#9
Registered User
Thread Starter
Join Date: Mar 2003
Location: Tucson AZ
Posts: 1,412
Likes: 0
Received 0 Likes
on
0 Posts
YES the 89 integra does work u just have to redrill the bracket a little to get it to mate up to the tranny of the zc but its quite simple with a high power drill