I am building a crx si with a d16z6, with new rings, rods, pistons, etc. along with ported, and polished head. I am also adding a 65 shot of nitrous, so things are getting a bit serious as I am putting this together. I want to order a clutch but don't know what stage I should go with. I want to basically never have to worry about replacing this clutch again, but I also want good drivability. I would like to be able to pull up beside a cop, and take off normally without fear of barking the tires accidently. I need to be able to put the power to the ground no matter what though, so I am kind of in a thin balance of clutches. I may turbo this car eventually also depending on what kind of deals I can run across. I can drive stick like no tomorrow, so I think I can get used to about any clutch easily but I don't want to have to rev my shit to 5 grand, then dump the clutch just to get moving.

I will appreciate any advice given. thanks

 

i have an act stage 1 clutch and its very easy to operate, gives smooth engagement and also holds well on a launch, all clutches take some getting used to but its like driving a new car u get the hang of it after driving it for a few days, i dont have any of this issues that u seemed concerned about