Ok so I striped all my civic's interior cause the carpet was all used and abused... I got two holes in the floor: one of them is located on the rear passenger side where the floor makes a 90 degree angle fo the rear seats and the other is on the driver's side floor and it's about the size of a quarter and the rest of that's spot is in pretty good shape but the color of the floor is pretty much rust. I went to a guy and he said he could cut the rusted and pierced floor pieces and tig weld a new floor that's the same shape (all the same humps and dumps and a little bit thicker) for not much $$$. Do you guys think I should go ahead and do it?

 

Go for it.

 

how much is "not much $$$" ?

 

Yes. Save it before it gets worse.

 

i agree with kai, get it fixed or else you will be rollin flinstons style

 

I would do both of the repairs for 300Can$ so that's about 200us$. Either way Ive seen some of the work he's done and it didn'teven show that there was some cutting and welding. Since I'm swapping a B16a I'll do it to keep that Ef as long as I can

 

I would do both of the repairs for 300Can$ so that's about 200us$. Either way Ive seen some of the work he's done and it didn'teven show that there was some cutting and welding. Since I'm swapping a B16a I'll do it to keep that Ef as long as I can

 

oups sorry for the double post