EGR, is it even hooked up??
06-27-2003, 07:42 AM
#11
Rotorphile.
Join Date: Mar 2002
Location: Richmond, VA
Posts: 10,120
Likes: 0
Received 0 Likes
on
0 Posts
I have nothing better to do, I think I'll run over to Burger King and get a picture of Hatch's engine bay and one of mine. (He may work at burger king, but at least HE has a job 
)
EDIT: OK, before I keep researching this and make a whole photo album/research paper, can you tell me what the casting code it on the front of your "Z6" head? It is in the area above the exhaust ports. If it is "P07-1" you have a problem, that is the casting code for a VX head. If that is the case, I don't even need to do a full write-up
)EDIT: OK, before I keep researching this and make a whole photo album/research paper, can you tell me what the casting code it on the front of your "Z6" head? It is in the area above the exhaust ports. If it is "P07-1" you have a problem, that is the casting code for a VX head. If that is the case, I don't even need to do a full write-up
07-02-2003, 09:54 AM
#12
Asianalize your car
Thread Starter
Join Date: Jun 2002
Location: Minneapolis
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
Nope, not a PO7, its a PO8 something. I'm pretty sure it's a Z6 head. I'm not real worried about this anymore, I've pretty much figured that both my heads have the EGR passage through the head, but neither of the passages are routed to the intake, and thus don't matter...
Jung
Jung