I bought a muffler off of e bay, this one
http://cgi.ebay.com/ebaymotors/HONDA...spagenameZWDVW

It looks fine, cool. I get it and it sticks 8 inches out the back of my car. Im embarrassed Could I get cut and welded down? to be flush with my bumper?

 

We've got to have pics so we can laugh and make fun of it. Sorry to hear of your misfortune. I'm sure you could have a professional welder cut out a section and weld it back to make it look how you want it.

 

Tomorrow ill try with my phone

P.S. Could you tell me how to post pics on the forum??

 

Yea, you can always have it cut down and rewelded... Take it to a muffler shop and they should do it for you... Probably wont be too much...

 

Do you think like 50$ or less?

 

Well, at a local shop, (I did get a small hook up tho), they replaced the whole center peice (from cat to rear muffler peice by the rear pass wheel) with 2.25" mandrel bent piping, and it cost me $80... So probably about $50 or so for something like that...

 

Well, when you get it welded and cut and all tell me how u like the sound of it.

 

What do you mean by JDM fart can. I know what JDM is, but what is the fart can? If you mean sticking with the stock muffler then, I would have had no problem with that, but mine had rust holes, and you could hear it from a mile away.

Anyways, I went to my TMA center, and they said $35, and I acceped and they did it all in like 8 minutes, and I love how it looks and sounds.(It is flush with that back bumper and it is not loud at all.

 

Hes just an obvious troll... Id just ignore him...

Glad to hear u got it fixed and for that cheap! :bigok:

 

do u have before and after pics?