Ok I recently bought a 91 CRX HF and dropped a b16a1 in it. I then put a light weight fly wheel, clutch and header in it. But now I am not shore where to go. I have 2g’s left in my build a REX account and need it to be pretty quick where do I go? I have already got the suspension and wheels on it.

 

should of got a B18C1 but nevermind just turbo it

 

I was looking more in to nonaspirated Engine work.

 

get some machine work done like a valve job or port and polish. or go with some cams and pistons. how bout both.

 

What kind of performance can I expect from that engine in stock form in my REX?
When I pot a more aggressive cam and valve train in the engine what kind of gains should I get? What would I have to do to my car to go with a 75 shot with worrying about blowing it?

 

Ok what would I need and how mooch would it cost to build my REX to out run a 1996 talon turbo with t3 turbo up grade? I hate that guy.

 

How about some ctr cams with upgraded springs and retainers. 2.5 or 2.25 catback. Have someone burn you an ecu chip. Aebs intake manifold with a ported typre rrrrrrrrrr throttle body, if you don't get a chip burned maybe get a vafc and raise your vtec a little bit to go with the ctr cams. Get some good tires on it, maybe lower it a few inches.

 

Where is a good place to get a chip?

 

I suggest sending your ecu away there are a few people on honda-tech that can do it for you, just post it up in electrical tech on there.

 

Skunk2 cams stage2
Skunk2 Cam gears
Skunk2 Valve springs
Retainers

AEM Throttle bodies
Intake manifolds skunk2
AEM Fuel rail

Fuel pump
Fuel pressure regulators
AEM Injectors

AEM Ignition systems
with this should i be good it's what i am ordering