crxresurrect

i am having problems with code 22 vtec oil pressure switch which i think a bad ground not sure and also code 10 is the intake air temp. and i was wondering if anybody can tell me where intake air temp. it is located at on the b16a1. When i start my car it takes it alittle bit to start when it starts it has a ruff time trying to idle smooth when it finally idles out its between 1000-2000rpms and then you give it the gas and it revs to about 5000rpm and cuts out and after about 2 to 3 mins of running the idle goes down and then it dies i was wondering if one of this code could be the problem or could it be valves need adjusting or anything advice would help. Thanks

ED9man

Check your wiring and check your vaccum.
I bet with confidence it is one of those.

Kai

The IAT is a little white sensor held into the manifold by two screws. It's usually on the #4 (right side) intake runner.