Helpppppppp!
#1
Helpppppppp!
okay heres my big problem. I have a 91 honda crx dx. I have a dx wiring harness which i converted to si for a zc swap. Now i am wanting to install a 1st gen b16a.
I need to know exactly where i need to wire everything, using the dx wiring harness.
Also, one of the two plugs that connect to the dist. cap. is round and has extra wires. the plug on the dx harness is square and has less wires.
I have the male connector from the b16a harness, do i just match the wires up? Its a blue/green and a blue yellow wire that are extra.
Basically im looking for a good wiring diagram for 91 dx to 1st gen b16a vtec.
I need to know exactly where i need to wire everything, using the dx wiring harness.
Also, one of the two plugs that connect to the dist. cap. is round and has extra wires. the plug on the dx harness is square and has less wires.
I have the male connector from the b16a harness, do i just match the wires up? Its a blue/green and a blue yellow wire that are extra.
Basically im looking for a good wiring diagram for 91 dx to 1st gen b16a vtec.