I'm getting mixed results when i am searching for this. Some websites say i need 88-89 axles to swap a b18a into my 91 hatch. I have also heard i could use the ones out of the 90-93 integra(which i have). Let me know if you have done this before or know the answer

 

I used the 90-92 axles and intermediate shaft on my swap in my hatch. They work fine if you remove the inner dust shield on the inside of the hub.

 

thanks, anybody else have some input to add on what they did?

 

That's exactly what you are supposed to do. 86-89 axles will be too short.

Any 90-93, manual transmission, non-ABS axles will work.

 

non abs? i think the 92 gs has abs....are they not useable?

 

I have one ABS axle and one Non-ABD axle on my car, they are the same and both will work. the ABS part of the axle has no affect on fitment.

 

I hope so. Kai, what do you think about this, you seem very knowledgeable about all this

 

The only real difference is the ABS sensor ring on the hub side, I'd just prefer non-ABS axles so I wouldn't have that ring there when it's not needed.

 

but i have abs axles already...they'll work the same right?

 

hey slammed91-hatch did your motor come with a transmission mount bracket on the rear? i need one of these for my 93 ls in 91 hatch and i dunno where to go. i dont feel like paying 80 bucks at a honda dealer....any ideas? and from what car?
oh i have 93 teg axels and they work fine, i just stuck them in =\