Installing/Rigging visor wires/lines
08-01-2011, 03:43 PM
#1
Member
Thread Starter
Join Date: Nov 2010
Location: Derwood,MD
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
Installing/Rigging visor wires/lines
So I wanted lighted visors for my wife's Xterra and found tha 5th gen visors fit perfectly. So I bought some and installed. Fit like a nitrile glove.
So I haven't looked yet to see if there's a plug that I can just plug-n-play but I suspect not b/c I "fingered" :naughty: around the visor hole and nothing.
I need ideas on how to perhaps rigging something to make them light up if key is in the ignition or parking lights are on. Not sure if it requires a relay or if I can just splice into a line since I don't think it'll take enough juice to require another relay. Ideas, suggestions?
So I haven't looked yet to see if there's a plug that I can just plug-n-play but I suspect not b/c I "fingered" :naughty: around the visor hole and nothing.
I need ideas on how to perhaps rigging something to make them light up if key is in the ignition or parking lights are on. Not sure if it requires a relay or if I can just splice into a line since I don't think it'll take enough juice to require another relay. Ideas, suggestions?
Last edited by CDelgado; 08-01-2011 at 03:47 PM.
