amp goes into test(protection) mode
I am having a hard time with my amp (see sig). It plays fine untill it goes into test mode. I have checked my ground wire a million times. I even tried a different bolt. all paint chiped off, straight to the chasis. I am sure its not the ground. It is also not overheating. Sometimes it shuts off after 10 minutes, othertimes 30 min. I am starting to think perhaps the power source is not stable enough ? but that is hard to believe because thats my only amp. Also, I shipped my amp to maxsonics and they shipped a new one back to me, and it does the same thing. Any thoughts ?
|
is your sub hooked up correctly? maybe the amp is seeing too low of an OHM rating.
what size power/ground do you have? are the gains turned too high? |
it does that with or without the sub. both power/ground are 4 guage.
|
how is the amp mounted? is it touching the cars chassis in anyway?
im just shooting out blank questions....:dunno: |
nop its not touching the chasis in any way. its in the trunk. this is very odd, i have tried everything really. it goes into protection randomly, sometimes it will take no time at all, other times 30 min. I cant figure out whats up.
|
is it not supposed to turn on at all with all speak wires out ? cause i took them all out and now it goes straight to protection mode.
|
it should turn on as long as there is power ground and remote. its probably the amp.
|
Originally posted by ChosenGSR is it not supposed to turn on at all with all speak wires out ? cause i took them all out and now it goes straight to protection mode. |
I'm sure you saw my answer on team-integra...
New twist on the story w/the no speaker connections connected. There has to be a short somewhere, that's for sure. It's possible that it's related to your rca's, remote wire, power/ground wires as well. Take the amp out and have it bench tested somewhere. If it works fine, something is wrong w/your wiring. If it fails a bench test, then get it replaced. Hifonics is a good brand and will take care of you. |
Hm, for some reason it goes straight into protection mode with no speakers in. But with speakers in it turns on, and then it goes intro portection after a while. my trigger wire goes from the antena trigger to the trunk where it splits to a preamp and the amp. it has no problem triggering the stuff on and off. Ground wire i tried 2 different bolts, so i doubt that is the problem. What could be wrong with the power wire ? and what could be wrong with the rcas ? This is driving me nuts, I am almost ready to find a place around here that would just take a look and fix all this for me. :mad: :(
|
All times are GMT -8. The time now is 08:15 PM. |
© 2024 MH Sub I, LLC dba Internet Brands