Kenwood
2-Channel Power Amplifier

Key Features

Maximum Output Power: 600 Watts x 1

Power Ratings

Power Output at 4 Ohms, at 14.4V (20Hz-20kHz,
0.08% THD): 100 Watts x 2
Power Output at 2 Ohms, at 14.4V (1kHz, 0.8%
THD): 150 Watts x 2
Bridged Power Output at 14.4V (1kHz, 0.8% THD):
300 Watts x 1
Maximum Output Power: 600 Watts x 1

Power Supply Features

Power MOSFET Switching Power Supply
Copper-Shielded EE Core Transformer
Large Toroidal Noise Suppression Filter
Black Anodized Top Cover: with Aluminum Heat
Sink Plate
Large Secondary Capacitors
Power Indicator
2-Ohm Stable

Audio Features

Stereo, Mono, or Tri-Mode Operation
Selectable Low-Pass Electronic Crossover
Ground Isolation Circuit
RCA Audio Inputs: Gold-Plated
Speaker Level Input Terminals: Screw-Type
Speaker Connectors: Gold-Plated, Screw-Type
Quiet Turn-On
Speaker Relay Protection

Is this a good amp?? I have two audiobahn 12 inch subs that can handle up to 400 watts, is this good enough to power the speakers correctly? or should i look for a better amp?

Also i do not really understand the difference between 2 ohms and 4ohms.

 

nobody has any input about this amp?

 

what configuration are your subs? are the dual voice coil and what ohms? If its enough will depend on how loud you want to get. I might look at a bit more power though.

 

would this sub be better for my mids and highs??