So I finally went and purchased Raammat60 and decided to put it in today. I bought 2 rolls of the stuff (60 mil) and started around 11AM. At 5pm I was no where close to being done. But in the process i realized that I need to redo my system the right way. I also noticed that one of my Infinity components has a crack in the woofer.
IS THERE ANY EASY WAY TO PUT THE DOOR PANELS ON!?
They are hard enough to get on any other time let alone with a layer or two of sound deadening
So where to go from here? I am going to invest in Q-logic kick panels to house my, soon to be ordered, Alpine SPX-177A's. I have everything apart in my car and now is as good of a time as any.

 

Just make sure you don't cover the holes up when you matt everything!

Make sure you have the window down when you go to put it on as well. I think they are extrememly easy to put on - it just takes some practice!

 

Cool yeah im gonna be puttin in raamat soon. I wish i could my alpines in kicks but just can't get rid of the dead pedal. They are a good sounding speaker i think. The door should just snap back on as long as you cut out the holes for the door clips. I jsut cut aroudn the hole a bit and haven't had any problems.

 

yeah at that point I was ready to pack it all in for the night. Try again tomorrow.