Clogged Windshield Washers
09-23-2003, 03:59 AM
#1
Junior Member
Thread Starter
Join Date: Aug 2003
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
Clogged Windshield Washers
I've got only one good stream of washer fluid out of 4 working. I've tried the clearing debris from the pinhole with a .... pin. Still getting NO fluid from the other 3 nozzles 
. Any ideas?
. Any ideas?
09-23-2003, 05:49 AM
#2
Huh???
Join Date: Jun 2003
Location: Rosarito, BC, Mexico
Posts: 158
Likes: 0
Received 0 Likes
on
0 Posts
Replace them. Or you might try taking them off and soaking them in vinegar overnight. Then try to clear the debris.
I dunno...never tried it...but vinegar removes hard water stains from my coffee pot. Worth a try anyways if you dont want to just replace them.
I dunno...never tried it...but vinegar removes hard water stains from my coffee pot. Worth a try anyways if you dont want to just replace them.
09-23-2003, 08:54 AM
#4
Registered User
Join Date: Sep 2003
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
i had to replaced my 3 times, each nozzle only last so long.. and they're honda nozzles too.. i have like 10 sets just, 6 left just in case it happens again.. they were like 10 dollars each.. wasn't sure if the after market was good
09-23-2003, 02:26 PM
#7
Junior Member
Join Date: Nov 2002
Location: long island
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
Try checking the fluid lines too. Mine were only shooting out of one hole and it turned out to be that i had a small crack in one of the lines, meaning that there just wasn't enough fluid actually making it to the nozzles to shoot out of all 4 holes.
09-24-2003, 12:54 PM
#8
Senior Member
Join Date: Jun 2002
Location: Raleigh, NC
Posts: 671
Likes: 0
Received 0 Likes
on
0 Posts
Try this: if you have an electric air pump and one of those small needles for blowing up basketballs, put the needle onto/into the washer hole and turn it on. You wouldn't believe how much crap was in that tiny little washer thing.
09-24-2003, 01:25 PM
#10
Jizz Maste12
Join Date: Jun 2002
Location: DISNEYLAND!
Posts: 702
Likes: 0
Received 0 Likes
on
0 Posts
Get some CLR (calcium, LIME,RUST) pour it into a cup and put your nozzles in there over night that would work... You should use windshiled wiper fuild instead of Tap water. Your house (tapwater) must have alot of minerals hhahaha you need to hook up a Water softener for your house.
*CLR (sliver bottle found @ your hardware store)
Or I can sell you mine! only used them for 3 months replaced them with LED nozzles hahaha
*CLR (sliver bottle found @ your hardware store)
Or I can sell you mine! only used them for 3 months replaced them with LED nozzles hahaha