before

after


pain in the ass to tear it out, but well worth it.

 

you need a better camera!
do you have to take out the bumper to take out the tails?
and how'd you take out the orange strip?

 

yes, more details please

 

u dont need to take off bumper, just unscerw 4 bolts holding it together. the whole tail light comes off. take out the bulb and look inside. i examined it, and the orange strips are quite small and it looks like this - |__|. i soldered it in half, horizontally, so there were two pieces like this - |__| |__|. becareful of soldering it cuz u might damage the lightbulb holes. push the two orange clamps in, so it falls in, and get a long thin pleirs to take them out. becareful, because there is silver paint inside to make it shine, and it can easily come off. so if the two parts dont come out at once, just solder it off piece by piece. and wallah ur done. dont forget to buy orange light bulbs too.

 

... can u show us a pic of where the 4 bolts holding the tails are?

 

no... cuz its already installed, the four bolts are in the corners, the top 2 bolts are covered with orange plastic caps

 

i was looking around for the bolts on the tails... i know how to take out the bulbs but i cant find them partly because of that black cover thing, covering the tails
so i dont know how to take out the tails.. :dunno:

 

just open ur trunk and remove the panel that covers the rear of the tails, one on each side of course. once you open the panel, you can see the bolts:thumbup:

 

open ur trunk, take of the big black, cover which holds in ur jack, etc., and u can clearly see the bolts behind the tail lights

 

haha i did, i still cant find the bolts!
do i have take off that whole black plastic cover on the whole trunnk???

all i saw was the bottom end of the screws but no bolts.. when i take off that cover thing