Passing wires thru firewall of 98 sedan.
#1
Registered User
Thread Starter
Join Date: May 2003
Location: Some where in Delaware
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
Passing wires thru firewall of 98 sedan.
I am ready to do my guage wiring, but can't find a hole thhru the wire wall. I need to seen just one wire. How can I do this?
#2
There is 2 different spots One on the passenger side and the other on the driver. If your battery is on the passenger side, I recommend you pull the wire on that side since that will reduce the length by about 2 or 3 feet. And vice versa if on the driver. On the passenger side, look where the fuse box is. If you look kind of behind an below it a bit, you will see a gromet back there where the other factory wires are run through. Just stick a coat hanger through and then go inside and see if you can find it. Once you find it, tape the wire on the end really good and just pull through. The one on the passenger side might be tough to get to, but better than running all over the place. Then on the driver side, if you look kind of where the steering is, you will find another grommet with factory wires pulling through. Just do the same on this side as you would with the passenger side.