Can it be done?
Thread Starter
Member
Joined: Oct 2006
Posts: 45
Likes: 0
Can it be done?
Is it possible to change my driver side rear bearing assembly, both rear rotors and pads, and shocks, in one day?
I plan on waking up early on saturday morning and tackling these task. Is it something I should be able to finish by like 8PM if I start at like 9AM?
Hopefully I should be able to gather all the parts and tools by friday so I'll be all set to go on Sat morning. What do you guys think?
I plan on waking up early on saturday morning and tackling these task. Is it something I should be able to finish by like 8PM if I start at like 9AM?
Hopefully I should be able to gather all the parts and tools by friday so I'll be all set to go on Sat morning. What do you guys think?
#CustomUserTitle
Joined: Mar 2002
Posts: 63,855
Likes: 1
From: glass case of emotion
year of the Accord and location?
Rear bearings are usually hub assemblies. They pop in and out as entire units. Not bad in theory, but if rusted on and stuck ... this will be a chore.
Shocks are easy in theory (again), but those springs might kill you ... literally. You have to be very very careful removing those or even trying to compress them again. You do have a spring compressor right?
Rear bearings are usually hub assemblies. They pop in and out as entire units. Not bad in theory, but if rusted on and stuck ... this will be a chore.
Shocks are easy in theory (again), but those springs might kill you ... literally. You have to be very very careful removing those or even trying to compress them again. You do have a spring compressor right?