i put in new gauges and now my needles are all jacked up wat to do??

 

even if youre 120% careful when removing the needles, there is a huge change of fucking up your gauge cluster.

 

is mine messed up?

 

yeah. they're fucked. what u do is take the glass out and plug in the cluster. and take out ur needles, for tach and speedometer.

for the tach, (if ur car runs normal) let it warm up, and keep the car running.
stick in teh needle at .8k rpm

and for the speedometer, (u gotta be care ful w/ this) drive the car and try starting the cruise control. cruise control sets at 25mph or above. as soon as your cruise starts, set it at that speed, stick in the needle at 25mph mark.

and for the temperature needle (again, if u car runs normal) stick it in at a little below half way mark whne ur car is warm.

gas needle ususally finds it way to the right spot so just fill up and push that in right above F

hope i got my point around. u can go through all that trouble to get it back to close, or u can just replace the cluster.

when u install the white face guages, u'r only suppose to lift the needles a little bit, not take em off.

 

yea i took the face off and quit lol
the needles work again.

now i have a new problem though, my seat belts and head unit dont workk
could it be the fuse

 

could be many things, check ur fuses first. if that seat belt starts bothering u a lot, just close ur door, pull the seat belts back as if u were driving, and right underneath the passenger seat, there's the seatbelt control module, just disconnect it. and then use the seat belts manually.

it'll get rid of the annoying seatbelt beep and the light on the cluster.

for the radio, 95% chance its ur fuse.

 

ok i found the box by the driver side foot rest, but which is the fuse for the head unit

the seat belt doesn't beep or anything it just doesn't go up and down anymore

 

it says on the box which fuse is for what. and the seat belts, just pull them back by hand and disconnect teh computer. that way they wont go forward when u exit the car. just unplug the seat belts manually

 

ok i checked all the fuses and there good......so any ideas?

 

yeah, it has the diagram on either side of the fuse cover.