Replaced the front dog bone mount, it helped a little but it still does it. Next step is to replace the tranny mount since the two side mounts seem to be in good shape. Any BTDT on the tranny mount? There is no rear motor mount, correct? Could this problem be a torque converter issue? Thanks for the help guys. Emmett

Also, I snapped the stud on the valve cover gasket, ordered a new one from the dealer, guess 18 lbs. was just too much. Does anyone know the specs for the valve cover nuts?

This is on the '92

 

Valve cover nuts are usually 8ft-lbs.

 

its the large motor mount under the intake manifold. Any suggestions on replacement? source?