Originally posted by Zuerst
Will heating it up with a cig lighter flame be enough? I just took the bumper off earlier before I post this thread and the plastic (or rubber?) is pretty thick... I mean you can't see where it is dented from the inside the bumper... I also notice that the body shop that did the the repair on the bent bumper a few years back from someone rear ending me didn't put some screws back; the bottom four screws of the rear bumper to be exact. Don't really need it, but it still pisses me off...
no no no .. don't use an open flame on plastic ... that shait will burn a hole right through the bumper. if you have a heat gun, just pass it over the dent for a min or two to get the area warm enough to push. (not too hot, or you'll just end up poking your finger through.)