anyone with a lip?
Thread Starter
Registered User
Joined: Jun 2003
Posts: 216
Likes: 0
Originally posted by skratchnsnift
basically, you line up the top of the lip to where the paint on the bumper ends... i started by drilling screws on the ends of the lip to the fender/wheel well and worked my way to the middle underneath the bumper... it took only about 6 screws in total... it'll fit terribly at first, but after some coaxing it'll start to look factory...
oh, and i used some basic metal screws with washers from Home Depot
basically, you line up the top of the lip to where the paint on the bumper ends... i started by drilling screws on the ends of the lip to the fender/wheel well and worked my way to the middle underneath the bumper... it took only about 6 screws in total... it'll fit terribly at first, but after some coaxing it'll start to look factory...
oh, and i used some basic metal screws with washers from Home Depot
did you have to take front bumper offf?
wooooo woooooooooo
Joined: Mar 2002
Posts: 3,134
Likes: 0
From: Twin Cities
Originally posted by remues
did you have to take front bumper offf?
did you have to take front bumper offf?
boom
Joined: Jun 2002
Posts: 420
Likes: 0
From: San Diego
Originally posted by Bakeoff
It's either that, or drive it up on ramps and lay on your back for an hour... If the bumper is off, it's WAY easier, and WAY faster.
It's either that, or drive it up on ramps and lay on your back for an hour... If the bumper is off, it's WAY easier, and WAY faster.
just make sure you line up the lip to where the paint stops
