hello, here for help again, ne one know how to put the front fendes for the feels wide body fender kit on? i managed to put the back on but the front dont fit in perfect, they stick out too far to get it to go under the tire well and i dont want to cut it to make it fit without gettin peoples advice, can fiberglass be bent because it seems like the fender sticks out too far because its too perpendicular..and advice, ne one put these on before?

 

it will flex huh? well how do u suggest i go about this? i need to bend it to make the upper portion of it less of an angle so that it doesnt protrude as far out. its not an actual new bumpers, its a piece that goes over the stock bumper and makes it appear like its wide body..the back is done, still trying to figure out the front

 

i dont understand this post,..pictures might help,..once i know what your talking about i might be able to help you

 

word of advice. DO NOT listen to fujiwara faggot. he recently tried to remove an engine with the axles and exhaust still connected. He has a clue about cars. Fiberglass will not bed. You best choice to get it to fit properly would be to cut and refiberglass and so forth.

Fiberglass does not bed. Urethane does.

 

and i suppose dumping bondo into a 1" deep pocket is a better idea? how about your brilliant plan to "french in" s2k headlights with a half gallon of bondo. you dont have a lot of room to talk.

 

Take it to a body shop. Fiberglass will not bend. It's just the good ol' crap quality I have seen in just about every feels kit. They always need to be fixed, they never bolt right up.

 

are you and fuji wara the ambiguously gay duo?

 

yea that makes more sense, cuz i couldnt figure a way to get it to flex, i don want to bolt it in and hope that doing that will bring it down under the fende, i believed from the start that i would have to cut it, i just wanted to get opinions before i did it