hi guys, which AEM CAI fits into a 98 hatch? thanks

 

i think i heard a 99-00si intake should fit...

 

did anyone have this same setup? if so, which CAI did u use?

 

The Si one would sit too high due to the differing t/b locations. You would most likely have to modify a GSR one to fit.

 

hmm true.. i just figured civic bay with a b-series engine would work...
get a 2 part, they are easier to mess with

 

I was told after doing a swap to buy the intake for the engine and make it fit.

 

yea... b18c tb sits lower than the b16a. but the b18c pipe goes under the fender waay more towards the center of the car than the si cai (which goes thru the hole left by the stock airbox by the fenderwell.) i think the easiest inake would be a short ram for a b18c.

 

Doesn't Injen make one for such an application... Or was it just the short ram?

 

Just get the one for the B18C1, a couple extra sleeves and clamps and make it fit. If you can do a swap, you should be able to customize an intake.