Notices

code 4 crank angle sensor 92 civic

Thread Tools
 
Old Dec 12, 2008 | 06:26 PM
  #1  
carcrazeeeee's Avatar
carcrazeeeee
Thread Starter
Junior Member
 
Joined: Jul 2004
Posts: 57
Likes: 0
Default code 4 crank angle sensor 92 civic

new dist, and i get a code 4, swapped it with my other civic and it still gets a code 4, but the other car did not?? so i dont think it is a bad distributor?? is it a wiring problem?? car wont rev past 3000rpms, when it gets there it goes up down, like the rev limiter?? some one said limp mode?? tried alot any ideas????? i cleared the codes, reset????
Reply
Old Dec 13, 2008 | 02:07 PM
  #2  
carcrazeeeee's Avatar
carcrazeeeee
Thread Starter
Junior Member
 
Joined: Jul 2004
Posts: 57
Likes: 0
Default this site is a JOKE!!!!!!!!!!!!!!!!!!!!!!!!

Ive posted 9 times on this site and never even gotten a responce, what is the problem???? This site is a joke. Seems like u only help the people u want to, anyhow i figured out the problem myself, but do u think im gonna share it with this site. Thats sad cuz i see alot of other people here with the same problem, and i could help, but since ive posted 9 different times, why should i??? Thanks alot for nothing
Reply
Old Dec 13, 2008 | 02:54 PM
  #3  
Civic2Scooby's Avatar
Civic2Scooby
 
Joined: Jul 2003
Posts: 28,282
Likes: 0
From: michigan
Default

nobody cares if you share, not everybody in here is a diagnostic miracle internet technician. OH wow you threw a code 4, there can only be one possible solution to your problem. I mean how would it be difficult for somebody to E-diagnose your problem with the MASSSIVE amounts of information you gave.....thanks for getting butt hurt and feel free not to come back.

Last edited by Civic2Scooby; Dec 13, 2008 at 02:55 PM.
Reply
Old Dec 19, 2008 | 11:07 PM
  #4  
carcrazeeeee's Avatar
carcrazeeeee
Thread Starter
Junior Member
 
Joined: Jul 2004
Posts: 57
Likes: 0
Default

i knew i would finally get some stupid reply. just goes to further show, and prove my point, THANKS DUDE!!!!!!!!!!!!! IF THE PROBLEM WAS SO SIMPLE HOW COME U OR NO ONE ELSE HAD ANYTHING TO SAY UNTIL NOW?? IT JUST DOESNT MAKE SENCE
Reply




All times are GMT -8. The time now is 07:39 PM.