Some site out there has the instructions on installing a mugen front lip... I bought mine and it didn't come with instructions and I have these bolts and brackets....

Hopefully one of you guys have seen the instructions or know how to install the lips.

 

Ahh, is this a Mugen front lip, or a Moogen front lip?

I have an imitation Mugen lip, it came with 4 screws to hold the lip to the fender wells, two sets of brackets and associated screws to hold the lip to the bumper.

The 4 screws are self explanatory, but the brackets are a b*tch to install. There are several places you can place the brackets under the front bumper, b/c there are stock mounting points for the factory lip.

I would have installed the brackets directly underneath the bottom grill, but they weren't long enough to reach the lip. I could've gotten equipment from home depot, but I was in a hurry, so I installed the brackets further outboard so they jounted on the lip behind the two little vents. You can see the bracket through the vents, but I plan to cut some metal sheeting and placing them behind the vents, because on the real Mugen lips there's a piece blocking the vents. Hope that helps.

 

I have the real one and the instructions came in Japanese so they wouldnt help you anyway unless you can read Japanese. If you want I will scan them and email them to you if you can read it.

 

nah thanks for your help anyways

 

It's pretty much self-explanatory. I didn't even use all the crap that came with it and it's held to speeds well over 100mph. (1) screw on each side....that's it! It holds well because the lip HUGS the bumper so much that you have to try and stretch it over.