1993 honda civic axle
#1
Member
Thread Starter
Join Date: Feb 2008
Location: City of Angeles
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
1993 honda civic axle
hello,
I was wondering if anyone can help me out. My axle poped out of my tranny as i was driving my car is drop someone told me it was probaly cause i hit somthing hard. Well n-e-ways im trying to but the axle back and it seems it dosent want to lock good. The axle locks but if i pull the axle towards me with a lil pressure it comes loose. My question is, IS this normal? if not what can i do.
Help
I was wondering if anyone can help me out. My axle poped out of my tranny as i was driving my car is drop someone told me it was probaly cause i hit somthing hard. Well n-e-ways im trying to but the axle back and it seems it dosent want to lock good. The axle locks but if i pull the axle towards me with a lil pressure it comes loose. My question is, IS this normal? if not what can i do.
Help
#2
Senior Member
Join Date: Oct 2008
Location: Sacramento
Posts: 254
Likes: 0
Received 0 Likes
on
0 Posts
From what I understand they pull out fairly easily. I would put it back in anf make sure it locks in. If it comes out again the only thing you can do is buy a new axle. They aren't to expensive they run about $80.
#3
Remove the axel and examine it to make sure the joints are not lock/sieze first. If good, reinstall. There is a excellent how to in the How-To forum for axel replacement.
#4
Check the condition of the lock ring if there is one at the end of the shaft that inserts into the tranny. If it's damaged then just replace it with a new ring. Oh and make sure the ring faces downward when installing it.
#6
Your Powder Coater
Join Date: Mar 2004
Location: Girard, Ohio
Posts: 4,463
Likes: 0
Received 0 Likes
on
0 Posts
this is the correct answer. There is no reason to replace the axle over this. The lock ring is the issue here.
#7
Member
Thread Starter
Join Date: Feb 2008
Location: City of Angeles
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
I but the axle back ( i did not change the lock ring) and it came loose again. I checked the lock ring and it looks ok do you guys think its the ring even though it look ok should i still change
#9
Member
Thread Starter
Join Date: Feb 2008
Location: City of Angeles
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
I push the axle in and it seem it locks a go under the car and the axle is really close to the tranny wall. But if i push it towards me a with a little pressure it comes loose