Top of shock tower.. is this good enough?
got JDM milk???
Joined: Jun 2002
Posts: 991
Likes: 0
Re: Top of shock tower.. is this good enough?
Originally posted by FLiPKiD
is this good enough? i cant get the nut any tighter
is this good enough? i cant get the nut any tighter
if you can't get it any tighter, then that's as far as it goes. that's is assuming that you clamped the top while wrenching on the nut.
wooooo woooooooooo
Joined: Mar 2002
Posts: 3,134
Likes: 0
From: Twin Cities
the other way to do it is to use some vice grips and hold the actual rod from the other end. Basically jack the car up, and grab it between the coils of the spring with the vice grips, and try tightening it more.
Thread Starter
Senior Member
Joined: Aug 2002
Posts: 140
Likes: 0
From: Las Vegas, Nevada
Originally posted by Bakeoff
the other way to do it is to use some vice grips and hold the actual rod from the other end. Basically jack the car up, and grab it between the coils of the spring with the vice grips, and try tightening it more.
the other way to do it is to use some vice grips and hold the actual rod from the other end. Basically jack the car up, and grab it between the coils of the spring with the vice grips, and try tightening it more.
Driving a Turbo 2L Terror
Joined: May 2002
Posts: 4,212
Likes: 0
From: Stafford, VA
Originally posted by Bakeoff
the other way to do it is to use some vice grips and hold the actual rod from the other end. Basically jack the car up, and grab it between the coils of the spring with the vice grips, and try tightening it more.
the other way to do it is to use some vice grips and hold the actual rod from the other end. Basically jack the car up, and grab it between the coils of the spring with the vice grips, and try tightening it more.
wooooo woooooooooo
Joined: Mar 2002
Posts: 3,134
Likes: 0
From: Twin Cities
Originally posted by FLiPKiD
does anyone have other opinions about holding the rod to tighten it? what Bakeoff suggested
does anyone have other opinions about holding the rod to tighten it? what Bakeoff suggested
Thread Starter
Senior Member
Joined: Aug 2002
Posts: 140
Likes: 0
From: Las Vegas, Nevada
i tried getting to the rod to tighten it, but the dust cover is in the way. i couldnt tighten it anymore..
The nut is so tight, what would be the chances of it popping off?
The nut is so tight, what would be the chances of it popping off?
that will mess up the rod...
