I got a setup from an 00 HX into my 99 EK. I ran all the wires and added the relay plus fuses and everything works but the power lock. I was looking online and found that you need the Lock Box Controller (I think thats what its called). I went and got one but now when I try to hook it up to the door panel and the wires for the driver side door doesnt have a plug for it??? There is a wire to the power door lock actuator but no plug for the box???

My Question: Is there a differance from the wiring in the door panel on the driver side in the HX and EX??? Is the complete wiring different between the two? Can I just get a driver side wire system and hook it up and will it work?

Thanks ahead of time!

 

wussup homie...forget about the doors. lets go RIDE.

anyways, eh i got a reply for my power door conversion. i guess the 96-98 ek locks run off the fuse box. thats why it doesnt have the pulg for the control box. 99-00 ek locks run off the control box located in driver door. and somehow i think we might need to replace the lock acuators too. my parts are all mix matched...i should of just pulled everything off from the same car. i still think i dont have the right floor harness.

 

If not in the driver door the 96 VTI-R Honda (Jap spec) Australian delivered is under the steering colum.

Hope this helps

Jdmderick

 

Do you have a picture of where its located?